Dissent Off-Road Overland Rear Bumper Storage Panel Swing-Out

This swing-out was developed for overland builds that demand organized, high-access storage without sacrificing durability or simplicity. A two-piece design allows the upper panel to angle forward to match the rear hatch contour, providing cleaner clearance and improved aesthetics. Mounting slots and hole patterns are laid out for high-load accessories like traction boards, fluid containers, and trail recovery gear.

The arm is built from 3/16-inch steel and reinforced internally for rigidity under trail load. Aluminum panels and risers keep weight low while maintaining structural strength for bolted-on gear. All mounting surfaces are laser-cut for consistency and backed by gusseted support where needed.

The 21.5-inch-wide by 40-inch-tall panel is split into two modular sections. The angled upper half mirrors the slope of the rear hatch glass for a tight, low-profile fit. Slotted and pre-drilled aluminum surfaces support a wide range of mounting systems without excess bulk or rattles.

Compatible with either driver- or passenger-side swing-arm positions. Fits Dissent Off-Road rear bumpers with swing-out mounting provisions. Panel hole layout supports RotopaX mounts, Maxtrax pin systems, and custom bracket setups.